Cirrus V6-2.5L VIN H (1995)
INSTALLATION
1. Set crankshaft sprocket to Top Dead Center (TDC) by aligning the sprocket with the mark on the oil pump housing, then back off to 3 notches
before TDC.
2. Set camshaft sprockets to the aligning marks on the sprockets with the marks on the rear timing belt cover.
3. Install timing belt on rear camshaft sprocket first and install a binder clip on the belt and sprocket so the belt will not slip out of position. Keeping
the belt taught, install under the water pump pulley and then around the front camshaft sprocket. Install an additional binder clip on the front
sprocket and belt.
4. Rotate the crankshaft to TDC. Continue routing the belt by the idler pulley and around the crankshaft sprocket to the tensioner Pulley
5. Apply rotating force to the crankshaft sprocket in the clockwise direction, to tension belt, check that all timing marks are aligned.