Cirrus V6-2.5L VIN H (1995)
Exhaust Manifold: Service and Repair
Fig. 12 Cross Over Pipe Attaching Volts
EXHAUST MANIFOLDS - REMOVAL
1. Raise vehicle and disconnect exhaust pipe from rear (cowl side) exhaust manifold at flex-joint. It may be necessary to remove the entire exhaust
system. Refer to procedure outlined in this section.
2. Remove bolts attaching cross-over pipe to manifolds. Remove assembly
Fig. 13 Rear Heated Oxygen Sensor
3. Disconnect Oxygen Sensor lead wire at the rear exhaust manifold.
4. Remove Power Steering pump bracket.
5. Remove nuts attaching rear manifold to cylinder head and remove manifold.
