Cirrus V6-2.5L VIN H (1995)
3. Disconnect quick connector at condenser. Remove liquid line from condenser. Use special tool kit 7193 to disconnect quick connector. Remove
line at condenser.
CAUTION: Cap all lines that are not being replaced and cap the condenser inlet.
Fig 64 Liquid Line At Receiver/Drier
4. Disconnect liquid line from the receiver/drier.
5. Remove the liquid line from the vehicle.
Installation
For installation reverse the above procedures.
NOTE: When charging system -- after replacing lines -- add 44 ml (1.50 oz) SP10 PAG (polyalkalene glycol) refrigerant oil or equivalent.