Cirrus V6-2.5L VIN H (1995)
Tail Lamp: Customer Interest
Tail Lamps - Repeated Moisture Build Up in Lens
NO: 08-18-95
GROUP: Electrical
DATE: Apr. 21, 1995
SUBJECT:
Moisture in Tail Lamps
MODELS:
1995 (JA) Cirrus
SYMPTOM/CONDITION:
Repeated moisture buildup in tail lamps that does not evaporate quickly when the lights are turned on. Can be more prevalent in one lamp.
DIAGNOSIS:
Remove and inspect affected lamp(s). If there are no obvious defects in the lamp such as a bad Weld or crack, inspect the vent holes for obstructions. If
the vent holes are open. attempt to dry the inside of the light by turning the lights on. Perform the repair procedure.
PARTS REQUIRED:
AR
4856408
Vent Tube
AR
4630158
Right Tail Lamp Assembly
AR
4630159
Left Tail Lamp Assembly
REPAIR PROCEDURE:
This bulletin involves adding and positioning a revised (pre-formed) vent tube.
1.
Disconnect wiring connector and remove lamp from vehicle.
2.
It tail lamp cannot be dried out, replace the lamp assembly. Before installing the new lamp assembly or dried out existing lamp, inspect the drain
hose configuration.
Tail Light Assembly Drain
3.
The drain hose should be a 900 preformed hose, P/N 4856408, at location "A" prior to 2/10/95 (MDH 02-10-XX) or location "B" after 2-10-95
(MDH 02-10-XX) as illustrated. If hose is at location "A" it should be routed to the inboard side of the wire connector as shown.
POLICY: Reimbursable within the provisions of the warranty
TIME ALLOWANCE:
Labor Operation No:
08-50-85-91 Vent Tube, Tail Lamp Assembly - Install 0.2 Hrs
Related Operations:
08-50-85-92 Lamp, Right Tail Assembly - Replace 0.1 Hrs.
08-50-85-93 Lamp, Left Tail Assembly - Replace 0.1 Hrs.
