Cirrus V6-2.5L VIN H (1995)
3.
Loosen the four shock absorber mounting bolts on the side you marked in step # 1.
4.
Remove the plastic locating pins from the shock bracket using a punch or pliers.
NOTE:
DO NOT LEAVE THE PLASTIC PINS IN THE CAVITY OF THE SHOCK TOWER, OBJECTIONABLE NOISE MAY RESULT.
5.
Position the shock assembly inboard/outboard as required to adjust the camber. Make sure the fore/aft position is the same as indicated by the
marks made prior to adjustment and the forward and rearward bolts have moved inboard or outboard equal amounts.
6.
Torque shock absorber mounting bolts to 90 Nm (68 ft.lbs.).
7.
Check front end alignment and set toe if required.
POLICY: Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
Labor Operation No:
02-00-01-90
Camber, Front Suspension Adjust
1.1 Hrs.
FAILURE CODE: XX - Service Adjustment