Cirrus V6-2.5L VIN H (1995)
Fig. 5 TCM Removal
Fig. 6 EGR Removal;
5. Remove screws holding Transmission Control Module (TCM) to bracket (Fig. 5). Swing TCM up to allow access to EGR screws (Fig. 6).
6. Remove screws holding EGR tube.
7. Remove EGR valve mounting screws. Remove EGR valve and transducer.
8. Clean gasket surfaces. Discard old gaskets. If necessary, clean EGR passages.
INSTALLATION
1. Loosely install EGR valve with new gaskets.
2. Finger tighten EGR tube fasteners.
3. Tighten EGR tube fasteners to 11 Nm (95 in lbs) torque.
4. Tightening EGR valve mounting screws to 22 Nm (200 in lbs) torque.
5. Clip solenoid to bracket.
6. Connect back-pressure hose to EGR valve and transducer.
7. Connect vacuum supply and outlet hoses to solenoid.
8. Attach electrical connector to solenoid.