Cirrus V6-2.5L VIN H (1995)
Fig. 17 Groove In Back Side Of Level Sensor
INSTALLATION
1. Insert level sensor wires into bottom of opening in module.
2. Wrap wires into groove in back of level sensor Fig. 17.
Fig. 18 Installation Channel
3. While feeding wires into guide grooves, slide level sensor up into channel until it snaps into place Fig. 18. Ensure tab at bottom of sensor locks in
place.
Fig. 19 Fuel Pump/Level Sensor Electrical Connector
4. Install level sensor wires in connector.
-
Push the wires up through the connector and then pull them down until they lock in place.
-
Ensure signal and ground wires are installed in the correct position Fig. 19.
5. Install locking wedge on connector.
6. Push connector up into bottom of fuel pump module electrical connector.
7. Install fuel pump module.
