Cirrus V6-2.5L VIN H (1995)
Throttle Body: Service and Repair
Fig. 7 Throttle Cable Attachment To Throttle Body
REMOVAL
1. Remove air tube from throttle body.
2. Remove throttle cable from the throttle body lever Fig. 7.
Fig. 8 Throttle Cable Attachment
3. Pry retainer tab back on throttle cable and slide cable out of bracket Fig. 8.
4. Slide speed control cable out of bracket if equipped Fig. 8.
5. Remove EVAP purge hose from nipple on throttle body.
6. Remove connectors from throttle position sensor and idle air control motor.
7. Remove bolts holding throttle body to intake manifold. Remove throttle body.
INSTALLATION
1. Attach electrical connectors to idle air control motor and throttle position sensor.
2. Position throttle body on intake and install mounting bolts. Tighten bolts to 28.25 Nm (250 in. lbs.).
3. Install speed control cable (if equipped) and throttle cable into throttle lever.
4. Install cables into cable bracket.
5. Install air inlet tube. Tighten clamps to 3 ± 0.5 Nm (25 ± 5 in. lbs.) torque.
