Cirrus V6-2.5L VIN H (1995)
Wheel Hub: Service and Repair
Front
1. Raise and support vehicle.
2. Remove cotter pin, lock nut and spring washer from front stub axle.
3. Lower vehicle, then loosen hub nut while vehicle is on the ground and brakes are applied.
4. Raise and support vehicle, then remove front wheel and tire assembly.
5. Remove front disc brake caliper and brake disc assembly and support aside from steering knuckle.
6. On models equipped with 15 inch wheels, remove lower ball joint heat shield from lower control arm.
7. On all models, remove attaching outer tie rod end to steering knuckle.
8. Using remover tool No. MB-991113, or equivalent, remove tie rod end from steering knuckle.
Fig. 1 Speed Sensor Cable Routing Bracket
9. Remove speed sensor cable routing bracket.
10. Remove cotter pin and castle nut from stud of lower ball joint at steering knuckle.
11. Turn steering knuckle so front of steering knuckle is facing as far outboard in wheelwell as possible. Lightly tap boss on steering knuckle to
separate from stud of lower ball joint. Do not hit lower control arm or ball joint grease seal.
12. Lift up on steering knuckle and separate from ball joint stud. Support driveshaft so it does not hang by inner Constant Velocity (CV) joint.
Fig. 2 Steering Knuckle & Outer CV Joint
