Concorde V6-2.7L VIN R (1998)
7.
Inspect the circuit board for the C29 capacitor (Figure 1).
8.
If the C29 capacitor is missing replace the RKE receiver module with p/n 04602269AA.
9.
Re-install Junction Block/Body Control Module.
10.
Route overlay antenna, p/n 05014753AA, along existing A-pillar wiring, adding spot tapes near existing clip locations. Place the antenna such that
one "loop" of the antenna lays across the top of the windshield (perpendicular to the A-pillar), and the other "loop" down the A-pillar (Figure 2).
11.
Tuck the "loop" of the antenna laying across the top of the windshield underneath the headliner.
12.
Route the connector for the antenna through an opening between the A-pillar sheet metal and the instrument panel, feeding it below the junction
block taking care to remain clear of the parking brake mechanism.
13.
Connect the white two-way connector (RKE Antenna Connector) from the overlay antenna to the bottom of the RKE receiver module.
14.
Tape the original two way antenna back upon itself to eliminate potential BSR.
15.
Replace A-Pillar trim and verify correct RKE function.
