chrysler Workshop Repair Guides

Chrysler Workshop Service and Repair Manuals

Garage Door Opener - Inadequate Transmitter Range|Page 6906 > < Diagram Information and Instructions|Page 6897
Page 1
background image

Garage Door Opener Transmitter: Customer Interest
Garage Door Opener - Inadequate Transmitter Range

NUMBER: 08-19-00

GROUP: Electrical

DATE: MAY 26, 2000

SUBJECT:
Garage Door Opener Transmitter Range

MODELS:
1998 - 2000 (LH) Concorde/Intrepid/LHS/300M

OVERVIEW:
This bulletin involves installing a supplemental antenna to the garage door opener transmitter.

SYMPTOM/CONDITION:
The garage door opener located in the Overhead Travel Information System (OTIS) may have a range drastically less than the owners original
transmitter.

DIAGNOSIS:
If the customer describes a functioning garage door opener with a reduced range compared to the opener manufacturers transmitter, perform the Repair
Procedure.

PARTS REQUIRED:

1

04602316AA

Antenna, Garage Door Opener

REPAIR PROCEDURE:

THIS REPAIR IS COMPATIBLE WITH DAIMLERCHRYSLER'S MOBILE SERVICE PROGRAM AND DOES NOT REQUIRE HOISTS OR
OTHER FULL SERVICE FACILITY SPECIAL EQUIPMENT.

1.

Open hood, disconnect and isolate the negative battery cable remote terminal from the remote battery post.

2.

Remove the overhead console attaching screw.

3.

Remove the overhead console by pulling it straight down. Use caution not to damage the wire harness.

4.

Disconnect the wire harness and remove the console.

5.

Tape back the existing wire loop antenna.

6.

Remove the four OTIS mounting screws from the overhead console and remove the OTIS.

Garage Door Opener - Inadequate Transmitter Range|Page 6906 > < Diagram Information and Instructions|Page 6897