Concorde V6-2.7L VIN R (1998)
Repair Procedure
1.
Lower window all the way down on affected door.
2.
Remove C-pillar flag cover.
3.
Place a piece of duct tape over the rear section of the belt molding weatherstrip to protect it (Figure 1).
4.
Hold door trim panel in position (push down along top edge) so the inner and outer weatherstrips are aligned.
5.
With an awl puncture the inner belt weatherstrip or drill a 1/8" pilot hole to mark the location on the sheet metal inner panel (Figure 1). The
mark/hole should be approximately 35 mm (1-3/8 in.) from the rear of the panel to avoid the locating hole already in the sheet metal inner.
6.
Cut away any portion of the black foam strip wrapped around the inner belt weatherstrip interfering with the awl hole. This is to allow the screw to
be visible for future repairs. **Install screw, p/n 06032723, on Dodge vehicles and other models if there is already anti-squeak tape on sheet metal.
For vehicles without anti-squeak tape proceed to step 7.**
7.
Mark the outline of the rear vinyl wrapped edge of trim panel on the sheet metal using a grease pencil (Figure 2).
8.
Remove door trim panel.
