Concorde V6-2.7L VIN R (1998)
9.
If not completed in Step 5, drill a 1/8" pilot hole through the sheet metal inner panel at the location marked in Step 5 (Figure 3).
10.
Replace the (2) white clips at the rear of the trim panel with p/n 06504014 **('98-'00 Model Years).**
11.
Replace the (1) green clip at the front of the trim panel with p/n 06503204 **('98-'00 Model Years).**
NOTE:
LH VEHICLE DOOR TRIM PANEL CLIPS ARE NOT REUSABLE ON **"98-"00 M.Y.** ANYTIME A DOOR PANEL IS REMOVED THE
CLIPS MUST BE REPLACED.
12.
Using the flocking tape, p/n 04773968, completely cover the grease pencil mark made in Step 7 (Figure 4).
13.
Install the door trim panel making sure all (3) clips are engaged, you should hear a snap as each engages.
14.
Make sure the inner and outer belt weatherstrips are properly aligned. Install a door trim panel screw, p/n 06032723, through the hole made in the
inner belt weatherstrip into the pilot hole in the sheet metal.
