Concorde V6-2.7L VIN R (1998)
Rear Parking Brake And Retainer Clip (Left)
3. Install Intermediate parking brake cable routing clip into place on left front of crossmember.
4. Reattach left forward lateral link to crossmember. Install mounting bolt though the front of the crossmember mount towards the rear. Do not install
and torque nut at this time.
Lateral Link Attachment To Crossmember
CAUTION: The bolts attaching the forward lateral links to the crossmember must be installed with the bolts pointing rearward to prevent damage
to the fuel tank and or fuel tubes. Also, when installing the bolt attaching the left rear lateral link, install the bolt pointing forward to prevent
damage to the fuel filler tube.
5. Raise the crossmember up against the frame rails. Install, but do not fully tighten, the 2 bolts attaching the rear of the crossmember to the frame
rails.
6. Raise the exhaust into place. Reattach the 3 exhaust hangers previously removed from the muffler and resonator.
7. Remove transmission jack supporting muffler and exhaust system.
8. Reinstall the fuel filler neck attaching screw and secure the fuel filler neck to the left frame rail.
9. Position the rear parking brake cables into crossmember alignment holes.
10. Install the retainer clips securing both rear parking brake cables assemblies to the rear suspension crossmember.
11. Reconnect the right rear parking brake cable to the intermediate parking brake cable.
12. Install the parking brake cable tensioner to the left rear parking brake cable.
13. Install the parking brake cable tensioner to the intermediate parking brake cable. Refer to Brakes and Traction Control for the required service
procedure to install and properly adjust the parking brakes.
14. Install the 4 bolts attaching both stabilizer bar isolator bushing retainers to the frame rails (the 2 rearward attaching bolts attach the front corners of
the rear suspension crossmember in place). Tighten the forward stabilizer bar isolator bushing retainer attaching bolts to 40 Nm (30 ft. lbs.).
Tighten the 2 rearward stabilizer bar isolator bushing retainer attaching bolts (which also serve as the front crossmember attaching bolts) to 100
Nm (75 ft. lbs.).
15. Tighten the rear suspension crossmember rear attaching bolts to 100 Nm (75 ft. lbs.).
16. Install the screw securing the brake tubes to the left stabilizer bar isolator bushing retainer.
17. Install the remaining 3 lateral links to the rear suspension crossmember. The forward lateral arm mounting bolts must point rearward, and the
rearward lateral arm mounting bolts must point forward.
CAUTION: The bolts attaching the forward lateral links to the crossmember must be installed with the bolts pointing rearward to prevent damage
to the fuel tank and or fuel tubes. The bolt attaching the left rear lateral link must be installed with the bolt pointing forward to prevent damage to
