Concorde V6-2.7L VIN R (1998)
7. Using a hammer and Installer Piston Caliper Boot, Special Tool C-4689 and Handle, Special Tool C-4171 or equivalents, drive boot into
counterbore of the caliper.
8. Install guide pin sleeves and bushings.
9. Install brake pads.
10. Before installing caliper assembly on vehicle, inspect brake rotor. If any conditions as described in Checking Brake Rotor for Runout and
Thickness are present the rotor, must be replaced or refaced. If the rotor does not require any servicing, install caliper assembly.
11. Install brake hose onto caliper using banjo bolt. Torque the brake hose to caliper assembly banjo bolt to 33 Nm (24 ft. lbs.). New seal washers
MUST always be used when installing brake hose to caliper.
12. Bleed the brake system.
Guide Pin Bushing Service
NOTE: The double pin caliper uses a sealed for life bushing and sleeve assembly. If required this assembly can be serviced using the following
procedure.
REMOVING CALIPER GUIDE PIN BUSHINGS
1. Remove caliper from brake rotor. Hang caliper assembly on a wire hook away from the brake rotor.
