Concorde V6-2.7L VIN R (1998)
Storing Caliper
6. If the caliper is not being completely removed from the vehicle, support the caliper firmly to prevent weight of caliper from damaging the flexible
brake hose.
Removing Or Installing Braking Disc
7. If required, remove rotor from hub by pulling it straight off wheel mounting studs.
INSTALL
CAUTION: Use care when installing the caliper assembly on the steering knuckle, so seals on caliper guide pin bushings do not get damaged by the
steering knuckle bosses.
1. Completely retract the caliper piston back into the piston bore of the caliper, if new brake shoes have been installed.
2. If removed, install rotor on hub.
NOTE: Make sure shoe retainer clips are in position between the shoe backing plates on each end of shoes before caliper installation.
3. Carefully position caliper and brake shoe assemblies over rotor using the reversed required removal procedure.
4. Install the banjo bolt connecting the flex hose to the caliper. One washer should be installed on each side of the flex hose fitting before installing
the banjo bolt. Tighten guide pin bolts to a torque of 48 Nm (35 ft. lbs.).
