Concorde V6-2.7L VIN R (1998)
in the socket on the CAB and carefully push it onto CAB as far as it will go. When connector is fully seated into the CAB socket push in the
connector lock as far as it will go. This will pull the 25 connector into the socket on the CAB and lock it in the installed position.
6. Install the 4 chassis brake tubes on the HCU. Tighten the chassis brake tubes to 17 Nm (145 inch lbs.).
7. Install the primary and secondary brake lines from the master cylinder on the HCU. Tighten the primary and secondary brake tubes to 17 Nm (145
inch lbs.).
8. Reinstall the transmission controller.
9. Reattach the washer bottle filler neck: to the radiator support.
10. Reinstall the speed control servo to its mounting studs and radiator support.
11. Remove brake pedal positioning tool.
12. Install the remote ground cable onto the ground stud located on left shock tower. Install the remote ground cable attaching nut and tighten to a
torque of 28 Nm (250 inch lbs.).
NOTE: The ICU may need to be initialized, using the DRB scan tool, after installation.
13. Bleed the base brakes and the ABS brakes hydraulic system.
14. Road test vehicle to ensure proper operation of the base and ABS systems.
