Concorde V6-2.7L VIN R (1998)
Reinforcement Panel
13. Remove the 4 bolts mounting the reinforcement to the instrument panel. Remove the reinforcement from the instrument panel. Remove the
diagnostic connector from the reinforcement.
14. Remove the lower A/C duct below the steering column. It is secured with 1 screw.
Fuse Junction Block
15. Remove the 2 lower mounting screws securing fuse junction block bracket to instrument panel end housing.
16. Remove the 2 screws securing fuse junction block upper edge to the instrument panel bracket. These screws are installed from above the right side
of the fuse junction block and mount to the left.
17. Remove the dome lamp wiring harness connector from the fuse junction block.
18. Move fuse junction block as far down and to the right as possible without causing damage to the harness or fuse junction block.
19. Remove left rear door opening sill cover.
20. Remove front seat belt anchor bolt at base of left B-pillar.
21. Pull back floor carpeting on left side of passenger compartment to reveal front park brake cable.
Front Park Brake Cable At Rear Floor Pan
