Concorde V6-2.7L VIN R (1998)
main cap tie (horizontal) bolts.
Figure 74-Main Bearing Cap Identification, Figure 75-Windage Tray
7. Install the inside main bearing cap bolts and tighten to 20 Nm + 1/4 Turn (15 ft. lbs. + 1/4 Turn).
8. Measure crankshaft end play. Refer to Service Procedures-Crankshaft.
9. Install connecting rods and measure side clearance. Refer to Service Procedures-Connecting Rod.
Figure 75 Windage Tray
10. Install windage tray. Lubricate bolts with engine oil and tighten to 27 Nm + 1/4 Turn (20 ft. lbs. + 1/4 turn).
11. Install the main cap tie (horizontal) bolts and tighten to 28 Nm (250 inch lbs.).
12. Install rear crankshaft oil seal retainer and oil seal.
13. Install oil pump assembly.
14. Install crankshaft sprocket.
15. Install timing chain.
16. Install timing chain cover.
17. Install cylinder head covers.
18. Install idler pulley bracket for accessory drive
19. Install oil pick-up tube and O-ring.
20. Install oil pan and oil filter.
21. Install oil dipstick tube.
22. Install engine assembly.
23. Fill engine crankcase with proper oil to correct level.
