Concorde V6-2.7L VIN R (1998)
Engine Mount: Service and Repair
Rear Mount
Figure 24-Engine Mounting-Right, Left, And Rear
Figure 25-Structural Collar
REMOVAL
1. Raise vehicle on hoist.
2. Support transaxle with a jack.
3. Remove isolator nuts from the mount to transaxle mount bracket.
4. Remove rear mount isolator bolts to crossmember and remove mount.
INSTALLATION
1. Position isolator onto crossmember.
2. Install bolts attaching isolator to crossmember and tighten to 33 Nm (250 inch lbs.).
3. Lower transaxle onto isolator
4. Install isolator nuts and tighten to 61 Nm (45 ft. lbs.).
5. Lower vehicle.
