Concorde V6-2.7L VIN R (1998)
Wiring Harness Connection To Solenoid
11. If equipped, connect the wiring harness connector onto the solenoid on the steering gear. Be sure wiring harness connector seal are on connector is
in good condition before installing connector on control module.
CAUTION: Before installing tie rods on steering gear be sure the tie rod spacer block inside the steering gear bellows is correctly aligned with
the bolt holes in the rack of the steering gear and the steering gear bellows.
12. Align center take off on steering gear with the tie rod assemblies. Install tie rod attaching bolts and washers into steering gear. Be sure washers are
installed between tie rods and steering gear. Tighten the tie rod to steering gear bolts to a torque of 77 Nm (67 ft. lbs.).
