Concorde V6-2.7L VIN R (1998)
^
If the resistance is greater than 8000(8K) ohms, replace the EGR valve as described on page 25-23 of the 1999 Concorde/Intrepid/LHS/300M
Service Manual (Publication No. 81-270-9140).
Connect harness, with a DRB III(R) exercise the EGR valve. If the new valve does not function, the PCM driver circuit for the EGR valve has
been damaged. Replace the PCM as described on page 14-49 of the 1999 Concorde/Intrepid/LHS/300M service Manual (Publication No.
81-270-9140).
NOTE:
DO NOT INSTALL THE ORIGINAL EGR VALVE. IT WILL DAMAGE THE NEW PCM.
Clear the DTC's and test the EGR system with a DRB III(R).
^
If the resistance is less than 100 ohms, then the PCM driver circuit for the EGR valve is damaged. Replace the EGR valve and PCM.
Clear the DTC's and test the EGR system with a DRB III(R).
NOTE:
THE FOLLOWING STEP IS REQUIRED BY LAW FOR THE 1998 MODEL YEAR.
3.
Type the necessary information on the "Authorized Modification Label", p/n 04275086, and attach the label near the VECI Label (Figure 2).
NOTE:
WHENEVER A POWERTRAIN CONTROL MODULE (PCM) IS REPLACED DUE TO FAILURE, THE SOFTWARE OF THE
REPLACEMENT CONTROLLER SHOULD BE VERIFIED FOR THE LATEST REVISION LEVEL. USE THE FLASH PROCEDURE TO
UPDATE REPLACED CONTROLLERS AS NECESSARY.
POLICY: Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
Labor Operation No:
25-01-45-93
EGR Valve Replace - 2.7L Engine
0.6 Hrs.
25-01-45-94
EGR Valve Replace - 3.2/3.5L Engine
0.4 Hrs.
25-01-45-95
EGR Valve And PCM Replace
0.8 Hrs.
2.7L Engine
25-01-45-96
EGR Valve And PCM Replace
0.6 Hrs.
3.2/3.5L Engine
FAILURE CODE: P8 - New Part
