Concorde V6-2.7L VIN R (1998)
programming.
If the PCM on the vehicle has already been updated or programmed, a NO UPDATES AVAILABLE message will be displayed. Check the part
number of the PCM on the vehicle and compare it to the part number displayed. If the PCM has already been updated, then another condition
exists that will require further diagnosis and repair.
9.
The MDS and DRB III(R) will prompt for any operator action needed during the remainder of the programming process.
NOTE:
THE FOLLOWING STEPS ARE REQUIRED BY LAW.
10.
Type the necessary information on the "Authorized Software Update Label" p/n 04669020 (Figure 2). Attach the label to the PCM and cover the
label with the clear plastic overlay.
11.
Type the necessary information on the "Authorized Modification Label" p/n 04275086 and attach the label near the VECI Label (Figure 3).
2.7L Thermostat and Heater Supply Hose Modification (Revised)
The 2.7L thermostat modification applies to engines with build codes prior to 04/20/98 (the engine build date is located on a label attached to the left
rear valve cover). In-plant modified thermostats may have a white paint dot on the thermostat housing. All 2.7L engines must have the heater hose
modification performed.
1.
Follow the procedures listed in the 1998 Concorde/Intrepid service manual publication number 81-270-8140 to remove the thermostat on 2.7L
engine applications.
WARNING:
DO NOT REMOVE THE PRESSURE CAP WITH THE SYSTEM HOT AND UNDER PRESSURE. SERIOUS BURNS FROM HOT COOLANT
CAN OCCUR.
