Concorde V6-2.7L VIN R (1998)
Fig 20 Level Sensor Installation
INSTALLATION
1. Insert level sensor wires in bottom of stand- pipe.
2. Wrap wires into groove in back of level sensor.
3. While feeding wires into standpipe, slide level sensor up into installation channel until it snaps into place.
-
Ensure tab at bottom of sensor locks in place.
4. Install level sensor wires in connector.
-
Push the wires up through the connector and then pull them down until they lock in place.
-
Ensure signal and ground wires are installed in the correct position.
5. Install retaining clip on connector.
6. Push fuel pump/level sensor connector up into bottom of fuel pump module electrical connector.
7. Install fuel pump module. Refer to Fuel Pump Module.