Concorde V6-2.7L VIN R (1998)
Link Attachment To Stabilizer Bar
6. Install stabilizer bar attaching link onto stabilizer bar. Install stabilizer link to stabilizer bar attaching nut. Tighten the stabilizer link to stabilizer
bar attaching nut to a torque of 95 Nm (70 ft. lbs.) using a crow foot wrench and torque wrench in place of the wrench on the attaching nut. Be
sure to use a wrench to hold the link stud in place while tightening attaching nut.
Wheel Speed Sensor At Adapter
7. Install rear wheel speed sensor into brake caliper adapter. Install head attaching bolt and tighten to 7 Nm (60 inch lbs.).
8. Install rear braking disc on hub. Carefully install rear brake caliper over braking disc and install on adapter. Tighten rear caliper assembly to
adapter mounting bolts to 22 Nm (192 inch lbs.).
9. Install wheel and tire assembly on vehicle. Then torque all wheel mounting stud nuts in proper sequence until all nuts are torqued to half
specification. Then repeat tightening sequence to full specified torque of 129 Nm (95 ft. lbs.).
10. Lower vehicle to the ground.
11. With the weight of the vehicle on the tires, tighten lateral link to spindle attaching bolt to 135 Nm (100 ft. lbs.).
12. Reconnect the radio speaker wiring to the rear speaker. Install rear radio speaker and mounting bracket using 4 screws.
13. Install both lower quarter and upper quarter trim panels Refer to Body and Frame for the required procedure to be used for this vehicle.
14. Install the rear seat back, and seat cushion. Refer to Body and Frame for the required procedure to be used for this vehicle.
15. Check and reset rear wheel TOE to specifications if required.
