Concorde V6-2.7L VIN R (1998)
7. Remove cable retainer clip from shift cable conduit bracket.
CAUTION: Column must be tilted fully upward to remove cable retainer clip.
8. From underhood side of dash panel, unseat grommet and pull cable from interior of vehicle.
9. Raise vehicle on hoist and unbolt fill tube bracket. Rotate fill tube to gain access to shift cable clamp.
10. Loosen shift cable clamp on transaxle.
11. Disconnect shifter cable from shift lever assembly at transaxle.
12. Remove cable from underneath vehicle.
INSTALLATION
1. Route new cable from underside of vehicle The cable must be routed between the engine block and the heater return tube.
2. Snap new transaxle cable on to transaxle shift lever assembly.
3. Set shift lever assembly in park position at transaxle. This is the most rearward position. Verify park sprag is fully engaged.
CAUTION: Park sprag must be engaged when adjusting linkage. Rock vehicle back and forth to ensure that park sprag is fully engaged.
4. Tighten shift cable clamp bolt.
