Concorde V6-2.7L VIN R (1998)
Outer C/V Joint Installed On Interconnecting Shaft
2. Install outer C/V joint assembly onto interconnecting shaft. Joint is installed on interconnecting shaft, by pushing interconnecting shaft into outer
C/V joint, until retaining snap ring is seated in groove on interconnecting shaft. Verify the snap ring is fully seated into groove on interconnecting
shaft.
3. Distribute 1/2 the amount of grease provided in seal boot service package (DO NOT USE ANY OTHER TYPE OF GREASE) into outer C/V joint
assembly housing. Put the remaining amount into the sealing boot.
Seal Boot Correctly Positioned On Interconnecting Shaft
4. Install outer C/V joint seal boot retaining clamp, onto interconnecting shaft. Install replacement outer C/V joint sealing boot onto interconnecting
shaft. Outer C/V joint seal boot MUST be positioned on interconnecting shaft, so only the thinnest (sight) groove on interconnecting shaft is
visible.
Crimping Tool Installed On Sealing Boot Clamp