Concorde V6-2.7L VIN R (1998)
LOOSENESS IN SYSTEM AND TIGHTEN FASTENER. DO NOT OVER ADJUST.**
**NOTE:
PERFORM STEPS 16 THROUGH 19 ON CONCORDE/LHS/300M VEHICLES. SKIP TO STEP 20 FOR INTREPID VEHICLES.
16.
Using the flocking tape, p/n 04773968, completely cover the grease pencil mark made in Step 1 (Figure 2). Extend the tape past the vinyl wrap on
the trim panel.
17.
Install the door trim panel making sure all clips (3 on front/2 on rear) are engaged, you should hear a snap as each engages.
NOTE:
INSTALL DOOR TRIM PANEL CLIPS STARTING AT REAR UPPER, THEN REAR LOWER, THEN FRONT (REAR DOORS). CLIPS MUST
BE SEATED BEFORE SCREWS ARE INSTALLED.
18.
Using a sharp utility knife cut the flocking tape along the edge of the door trim panel (Figure 3). Care must be used not to cut too deep into the
metal and not cutting the vinyl on the panel.
19.
Remove the excess flocking tape.**
20.
Verify function of remote handle and door lock, courtesy lamp, window switches, power mirror, and speakers.
21.
Repeat procedure on other window regulators as necessary.
