Concorde V6-201 3.3L VIN T FI (1993)
2.
Remove the air filter assembly from the vehicle.
3.
Disconnect the 4-way ignition coil pack connector from the ignition coil pack and connect it to the service wiring harness as shown in Figure 6.
4.
Fasten the service harness ground eyelet to the engine as shown in Figure 7. Route the ground eyelet wire above the EGR solenoid to prevent the
wire from contacting the exhaust manifold. The torque requirement for the ground bolt is 300 in.lbs. (25 ft.lbs.).
