Concorde V6-201 3.3L VIN T FI (1993)
6.
Route the service wiring harness as shown in Figures 3 and 4. Use tie straps in indicated areas to secure the harness to the vehicle. Be sure to keep
the harness away from hazardous areas (sheet metal edges, heater hoses, exhaust manifolds, etc.).
7.
Fasten the service harness ground eyelet to the right frame rail as shown in Figure 4. The torque requirement for the ground eyelet screw is 35
in.lbs. (3 ft.lbs.).
8.
Disconnect the 60-way electrical connector from the Powertrain Control Module.
9.
Remove the wire shield from the 60-way connector.
10.
Remove the red locking wedge from the 60-way connector to access pins 17, 18 and 19. See Figure 5.
11.
Extract the circuits from cavities 17, 18 and 19.
12.
Install the service wiring harness circuits in the 60-way connector, placing the black wire into cavity 17, the red wire into cavity 18 and the white
wire into cavity 19.
13.
Re-assemble the 60-way connector and connect it to the Powertrain Control Module. Torque the 60-way bolt to 35 in.lbs. (3 ft.lbs.).
14.
Re-connect the battery, install the air filter assembly and test the system.
3.5 Liter Engine
1.
Disconnect the battery.
