Concorde V6-201 3.3L VIN T FI (1993)
9.
Install screws, **p/n K6504837AA**, to hold check strap to door end frame.
10.
Install two new pin clips, p/n K6031147, onto the hinge pin and seat both clips firmly against the check strap arm using large jaw slip-joint pliers
with a 5/16" nut attached as shown.
NOTE:
THE FRONT DOOR HINGE PIN LENGTH ON EARLY BUILT 1993 VEHICLES IS SLIGHTLY SHORTER (0.5 mm) THAN THOSE ON
LATER BUILT VEHICLES. AS A RESULT, ONE PIN CLIP MUST LOCK INTO THE HINGE PIN GROOVE ON EARLY BUILT VEHICLES
WITH THE SECOND CLIP PRESSED FIRMLY BENEATH. BOTH PIN CLIPS MUST LOCK INTO THE HINGE PIN GROOVE ON LATER
MODELS.
11.
Install door trim panel.
12.
Repeat procedure on other doors as necessary.
POLICY: Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
Labor Operation No:
23-40-27-90 Replace, Right Front
0.3 Hrs.
23-40-27-91 Replace, Left Front
0.3 Hrs.
23-40-27-92 Replace, Right Rear
0.3 Hrs.
23-40-27-93 Replace, Left Rear
0.3 Hrs.
FAILURE CODE: P8 - New Part
