Concorde V6-201 3.3L VIN T FI (1993)
Water Pump: Service and Repair
Removal
WARNING: Do not remove pressure cap with the system hot and pressurized. Serious burns from coolant can result.
NOTE: The water pump can be replaced without discharging the air conditioning system.
Fig. 17 Water Pump
REMOVAL
NOTE: It is normal for the water pump to weep a small amount of coolant from the weep hole (black stain on water pump body). Do not replace
the water pump if this condition exists. Replace the water pump if a heavy deposit or a steady flow of green-brown engine coolant is evident on the
water pump body from the weep hole (shaft seal failure). Be sure to perform a thorough analysis before replacing water pump.
1. Drain Cooling System in suitable container.
2. Remove Accessory Drive Belt.
3. Remove pump pulley bolts and remove pulley.
4. Remove pump mounting screws. Remove pump.
Fig. 18 Water Pump Body
5. Remove and discard 0-ring seal.
6. Clean 0-ring groove and 0-ring surfaces on pump and chain case cover. Take care not to scratch or gouge sealing surface
