chrysler Workshop Repair Guides

Chrysler Workshop Service and Repair Manuals

Engine Mount|Service and Repair > < Engine Mount - Rattle During Start Up and Shut Down
Page 1
background image

Engine Mount: All Technical Service Bulletins
Engine Mount - Rattle During Start Up and Shut Down

NO.: 09-05-93

GROUP: Engine

DATE: May 14, 1993

SUBJECT:
Engine Mount Start-Up and Shut-Down Noise

MODELS:

1993

(LH) Intrepid/Vision/Concorde 

1994

(LH) LHS/New Yorker

SYMPTOM/CONDITION:

Some vehicles may exhibit a rattle during engine start-up and/or shut-down. The rattle lasts for approximately one second. The presence of the noise is
not dependent on engine or air temperatures.

DIAGNOSIS:

Raise vehicle on hoist and make sure all front and rear engine support fasteners are tightened to specifications. Also, make sure all exhaust system
fasteners are tightened to specifications. Make sure the exhaust system components are not contacting the underbody or engine cradle. If the vehicle still
exhibits a rattle when the engine is started and/or when it is shut down, use a stethoscope to listen to the front engine mounts as the noise occurs. If the
noise is coming from the engine mounts, proceed with the repair procedure. The front engine mounts should be replaced in pairs only.

PARTS REQUIRED:

2

Engine Mount

4663526

REPAIR PROCEDURE:

Replace both front engine mounts as outlined in the 1993 Concorde, Intrepid, Vision Service Manual (Publication No. 81-270-3140).

POLICY:
Reimbursable within the provisions of the warranty.

TIME ALLOWANCE:
Labor Operation No.

09-40-20-96

0.8 Hrs.

FAILURE CODE: P8 - New Part

Engine Mount|Service and Repair > < Engine Mount - Rattle During Start Up and Shut Down