Concorde V6-201 3.3L VIN T FI (1993)
3.
Place the tensioner in a vice, and slowly compress the plunger. Install a pin through the body and plunger to retain plunger in place until tensioner
is installed.
4.
Apply Mopar Bond All Gel (P/N 4467709) to bottom outside edge of the Timing Belt Tensioner Pivot Snubber.
5.
Install the Snubber, with the word "TOP" facing up, on top of the tensioner body with the snubber centered over the plunger.
6.
Install the timing belt tensioner to the engine following the procedure outlined in the service manual.
7.
Align the camshafts following the procedure outlined in the service manual under "Camshaft and Timing Belt - Installation and Timing Procedure"
page 9-44.
NOTE:
INSPECT THE TENSIONER PULLEY BRACKET PIVOT BOLT FOR BINDING OR TIGHT SPOTS. THE PIVOT BOLT SHOULD
ROTATE FREELY. IF BINDING IS FOUND, REMOVE THE PIVOT BOLT AND CLEAN ANY DEPOSITS ON THE BOLT WITH STEEL
WOOL OR EMERY CLOTH.
POLICY:
Reimbursable within the provisions of the warranty.
TIME ALLOWANCE
Labor Operation No.
09-10-08-90
1.3 Hrs.
FAILURE CODE: P8 - New Part
