Concorde V6-201 3.3L VIN T FI (1993)
6. Index outer adjuster. Remove lock bracket and back out adjuster exactly one revolution. Then remove differential cover.
7. Remove The inner adjuster lock bracket. Then remove the inner adjuster.
CAUTION: Keep the inner adjuster for reinstallation.
8. Remove the transfer shaft nut, rear cone, rear cup, oil baffle, rear shim, transfer shaft and transfer shaft seals.
CAUTION: Keep rear shim and rear bearing cup and cone for reinstallation.
9. Install transfer shaft, transfer shaft seals, oil baffle, rear cup, rear shim, rear cone and a new nut.
10. Install a new O-ring onto the inner adjuster.
11. Lube inner adjuster threads and O-ring with gear oil and reinstall to the cross haired index marks.
12. Reinstall the inner adjuster locking bracket.
13. Install the differential carrier. Install stub shaft seal protector.
14. Install the differential cover/outer adjuster assembly with MOPAR Silicone Sealant applied. Install and tighten differential cover bolts.
15. Tighten the outer adjuster 3/4 of a turn. Seat bearings by turning differential carrier three or four turns in both directions. Finish tightening the
adjuster 1/4 turn to its index mark (original location).
16. Reinstall the outer adjuster locking bracket.
