Concorde V6-201 3.3L VIN T MFI (1994)
Drive Chain: Customer Interest
A/T - Buzz Or Rattle Noise
NO: 21-15-94
GROUP: Transmission
DATE: Sep. 2, 1994
SUBJECT:
Transmission Buzz or Rattle Noise
MODELS:
1993 - 1994 (LH) Concorde/Intrepid/Vision/LHS/New Yorker
SYMPTOM/CONDITION:
Buzz or rattle (tinny/metallic sound) short in duration, typically in the 10 to 15 MPH range on moderate acceleration which gets louder as the vehicle
warms up to operating temperature. The sound can only be heard while the vehicle is moving straight ahead or in a right turn. It is not present while the
vehicle is in a left turn.
DIAGNOSIS:
1.
Road test the vehicle at normal operating temperatures for the condition by starting from a complete stop in overdrive gearshift position.
2.
Moderately accelerate the vehicle and listen for the sound while traveling between 10 and 15 MPH.
3.
Repeat this while making a turn to the right.
4.
Repeat again while making a left turn. If the sound is heard in the straight forward and right turn maneuvers and not heard while making a left turn,
proceed with the following repair.
5.
If the sound is heard while making a left turn, follow the procedures listed in the appropriate Service Manual (Group 21) Transaxle under
Diagnosis Guide - Abnormal Noise and repair as required.
PARTS REQUIRED:
1
4778989
Kit - Transfer Chain Snubber
Consists of:
1
4659187
Transfer Chain Snubber
2
6503931
Screw - Chain Snubber Attaching (pilot point)
REPAIR PROCEDURE:
This bulletin involves replacing the transfer chain snubber and attaching screws.
1.
Follow the proper procedures and remove the exhaust system.
2.
Place a transmission jack under the transaxle and raise the transaxle slightly to relieve the weight on the rear transaxle mount.
3.
Remove the transaxle mount through-bolt.
4.
Remove the four rear crossmember mounting bolts.
5.
Remove the four mounting bolts of the transaxle mount.
6.
Lower the transaxle slightly and remove the rear crossmember.
7.
Remove the transaxle rear cover.
