Concorde V6-215 3.5L SOHC (1996)
21.
Remove the protective cap from the pressure test port on the fuel rail (Figure 8).
WARNING:
Do not allow fuel to spill onto the engine intake or exhaust manifolds. Place shop towels under and around the pressure port to absorb fuel
when pressure is released from the rail.
22.
Obtain the hose from the fuel pressure gauge tool set 4C-4799-A. Position one end of the hose into an approved gasoline container, then attach the
hose to the fuel rail test port to release the fuel pressure.
23.
Remove the hose from the fuel rail and reinstall the test port cap.
24.
Disconnect the fuel pressure regulator vacuum hose.
25.
Disconnect the coolant temperature sensor electrical connector.
26.
Remove the six (6) fuel rail mounting bolts (Figure 9).
27.
Remove the inlet and outlet rail retainer screws (Figure 9).
28.
Slide the inlet rail retainer toward the front of the inlet rail and lift retainer off rail (Figure 9).
29.
Slide the outlet rail retainer toward the rear of the outlet rail and lift retainer off rail (Figure 9).
