Concorde V6-215 3.5L SOHC (1996)
5. Rotate fill tube to original location. Install and tighten fill tube bracket bolt.
6. Route transaxle shift cable through hole in dash panel.
7. Install cable grommet in dash panel.
8. Route transaxle shift cable along steering column.
9. Connect transaxle shift cable to shift cable conduit bracket and secure with new clip.
10. Attach shift cable (with shift lever in park position) to attaching stud (pin) by snapping into place.
11. Shift the transaxle lever to park. Move the steering column to full tilt downward. Put the column shifter in park with key removed.
12. Adjust cable by rotating the adjuster into lock position. The adjuster will click when lock is fully adjusted.
13. Reinstall upper and lower steering column shrouds. Then install underpanel silencer/duct.
14. Check shifter for proper operation. It should operate smoothly without binding. The engine starter should crank in Park or Neutral positions only.
