Concorde V6-3.2L VIN J (2000)
1. Place hinge in position on vehicle.
2. Install bolt and nut attaching hinge to hinge pillar. Tighten the hinge bolt to 28 N.m (250 in.lbs.) torque.
3. Install bolt and nut attaching hinge to front door. Tighten the hinge bolt and nut to 28 N.m (250 in.lbs.) torque. If the double ended stub is
removed or replaced tighten the stud to 14 N.m (120 in.lbs.) torque.
4. Verify door alignment and operation, adjust as necessary.
INSTALLATION - DOOR HINGE DOUBLE ENDED STUD
NOTE: Replacement hinge studs have thread sealer on threads. When reusing original studs, use Mopar(R) Lock and Seal Adhesive or equivalent on
stud threads.
1. Install double ended stud into the door frame. Tighten the double ended stud to 14 N.m (120 in.lbs.) torque.
2. Install hinge. Tighten the hinge bolt and nut to 28 N.m (250 in.lbs.) torque.
3. Verify door alignment and operation, adjust as necessary.
