Concorde V6-3.2L VIN J (2000)
12.
Using the flocking tape, p/n 04773968, completely cover the grease pencil mark made in Step 7 (Figure 4).
13.
Install the door trim panel making sure all (3) clips are engaged, you should hear a snap as each engages.
14.
Make sure the inner and outer belt weatherstrips are properly aligned. Install a door trim panel screw, p/n 06032723, through the hole made in the
inner belt weatherstrip into the pilot hole in the sheet metal.
15.
Using a sharp utility knife cut the flocking tape along the edge of the door trim panel (Figure 5). Care must be used not to cut too deep into the
metal and not cutting the vinyl on the panel.
16.
Remove the excess flocking tape.
17.
Clean grease pencil mark off door.
18.
Install C-pillar flag trim.
19.
Remove the duct tape from the outer belt molding.
20.
Verify function of remote handle and door lock.
21.
Repeat procedure on other rear door if necessary.
