Concorde V6-3.2L VIN J (2000)
Power Door Lock Actuator: Testing and Inspection
Make certain battery is in normal condition before circuits are tested.
To determine which motor is faulty, check each individual door for electrical lock and unlock or disconnect the motor connectors one at a time, while
operating the door lock switch. In the event that none of the motors work, the problem maybe caused by a shorted motor, a bad switch or a bad relay.
Disconnecting a defective motor will allow the others to work.
Front Door Lock Motor
To test an individual door lock motor, disconnect the electrical connector from the motor. To lock the door, connect a 12 volt power source to the
positive pin of the lock motor and a ground wire to the other pin. To unlock the door reverse the wire connections at the motor pin terminals. If these
results are NOT obtained, replace the motor.
