Concorde V6-3.2L VIN J (2000)
Seat Heater: Testing and Inspection
Before testing the individual components in the heated seat system, check the following:
If the heated seat switch LED doesn't light up with the ignition in the ON position, and the switch in the LO or HI position, check the battery voltage, If
the battery is below 10 volts, recharge the battery. If the problem persists, then check the fuse in the junction block. If the fuse is OK, test the heated seat
switch as described. If not OK, repair the shorted circuit or component failure and replace the faulty fuse.
-
If the heated seat LED's light up, but the heating elements don't heat, check the circuit breaker in the junction block. If the circuit is OK, test the
heated set elements as described, otherwise replace the faulty circuit breaker.
-
Using a DRB III scan tool, check DTC's and refer to the proper Body Diagnostic Procedures.
