Concorde V6-3.2L VIN J (2000)
Storing Caliper
5. Support caliper assembly firmly from rear strut to prevent weight of caliper from damaging the flexible brake hose.
6. Remove the rear rotor from hub by pulling it straight off the wheel mounting studs.
INSTALLATION
NOTE: Step 1 below is only required when installing the disc brake caliper after new brake shoes have been installed.
1. Completely retract caliper piston back into piston bore of caliper assembly.
2. Lubricate both adapter abutments with a liberal amount of Mopar Multipurpose Lubricant, or equivalent.
3. Install the rear rotor on the hub, making sure it is squarely seated on the face of the hub.
CAUTION: Use care when installing the caliper assembly onto the adapter, so the caliper guide pin bushings do not get damaged by the
mounting bosses.
4. Carefully lower caliper and brake shoes over rotor and onto the adapter using the reverse procedure for removal.
