Concorde V6-3.2L VIN J (2000)
Rear Rotor Thickness Markings
NOTE: All rotors have markings for minimum allowable thickness cast on an un-machined surface of the rotor.
Minimum allowable thickness is the minimum thickness which the brake rotor machined surface may be cut to.
CAUTION: Do not machine the rotor if it will cause the rotor to fall below minimum thickness.
Before installation, verify the brake rotor face and the hub adapters are free of any chips, rust, or contamination.
When mounting and using the brake lathe, strict attention to the brake lathe manufacturer's operating instructions is required.
Machine both sides of the brake rotor at the same time. Cutting both sides at the same time minimizes the possibility of a tapered or uneven cut.
SPECIFICATIONS AND LIMITS
When refacing a rotor, the required 0.08 mm (0.003 inch) TIR (Total Indicator Reading) and 0.013 mm (0.0005 inch) thickness variation limits
MUST BE MAINTAINED. Extreme care in the operation of rotor turning equipment is required.
BRAKE ROTOR REFINISHING LIMITS CHART
