Concorde V6-3.2L VIN J (2000)
Fig. 99
7. Remove oil pan (Fig. 99).
8. Remove oil pan gasket.
9. Clean oil pan and all gasket surfaces.
INSTALLATION
Fig. 100
1. Apply a 1/8 inch bead of Mopar\e1m\e0m Engine RTV GEN II at the parting line of the oil pump housing and the rear seal retainer (Fig. 100).
2. Install oil pan gasket to the engine block.
3. Install pan and attaching fasteners (Fig. 99).
4. Install the structural collar (Fig. 98), using the follow procedure:
a. Install the vertical collar to oil pan bolts. Pre-torque bolts to 1.1 Nm (10 in. lbs.).
b. Install the horizontal collar to transmission bolts and tighten to 55 Nm (40 ft. lbs.).
c. Starting with center vertical bolts and working outward, final torque all bolts to 55 Nm (40 ft. lbs.).
5. Lower vehicle and install dipstick and tube.
6. Fill engine crankcase with proper oil to correct level.
7. Connect negative cable.
