Concorde V6-3.2L VIN J (2000)
2. Remove instrument panel.Refer to: Body and Frame, Interior Trim, Dashboard/Instrument Panel/Service and Repair, Instrument Panel
Service Procedures, See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and Repair
3. Remove actuator retaining screws. Pull actuator straight off recirculation door shaft. Upon removal, note the shaft position of the actuator, because
the shaft on this motor is keyed. When installing new actuator, its shaft must be positioned in the same location.
4. Disconnect electrical connection.
5. Remove recirculation door motor from vehicle.
INSTALLATION
For installation, reverse the above procedures.
