Concorde V6-3.2L VIN J (2000)
Brake Lamp: Service and Repair
Tail/Stop/Back-Up/Turn Signal Lamp Replacement
REMOVAL
1. Release decklid latch and open decklid.
2. Remove fasteners attaching trunk lining to lower rear trunk panel.
3. Move the trunk lining to access the tail lamp fasteners.
Tail, Stop, Back Up, And Turn Signal
4. Remove nuts attaching tail lamp to lower trunk and quarter panel.
5. Remove tail lamp from vehicle.
6. Disconnect tail lamp wire connector from body wire harness.
INSTALLATION
1. Connect tail lamp wire connector to body wire harness.
2. Place tail lamp in position on vehicle.
3. Install nuts to attach tail lamp to lower trunk and quarter panel.
4. Place trunk lining in position on lower trunk panel.
5. Install fasteners to attach trunk lining to lower rear trunk panel.
6. Verify lamp operation.
