Concorde V6-3.2L VIN J (2000)
Knock Sensor: Service and Repair
Knock Sensor
This engine uses one sensor. The sensor screws into the cylinder block, directly below the intake manifold.
REMOVAL
1. Remove intake manifold plenum.
2. Disconnect electrical connector from knock sensor.
3. Use a crows foot socket to remove the knock sensors.
INSTALLATION
1. Install knock sensor. Tighten knock sensor to 10 Nm (7 ft. lbs) torque. Over or under tightening effects knock sensor performance resulting in
possible improper spark control.
2. Attach electrical connector to knock sensor.
3. Install intake manifold plenum.
