Concorde V6-3.2L VIN J (2000)
5. Using a 1-5/16 inch crow foot, loosen the solenoid control valve. Then by hand, remove the solenoid control valve from the power steering gear.
INSTALL
1. Inspect the O-ring seals on the solenoid control valve to be sure they are not damaged. If the O-rings are not damaged, moisten the O-rings using
only fresh clean Mopar Power Steering Fluid, or equivalent.
2. Install the solenoid control valve into the steering gear by hand, until it is fully seated into the steering gear.
3. Using the 1-5/16 inch crow foot as shown in tighten the solenoid control valve to a torque of 14 Nm (124 inch lbs.).
4. Reconnect the power steering hoses at the gear. Tighten both hose tube nuts to 31 Nm (275 inch lbs.).
5. Route the solenoid control valve wire harness over the top of the gear and clip it into place on the gear end cap.
6. Connect the wiring harness connector. Be sure the wiring harness connector seal is in good condition before installing the connector in the control
module.
7. Road test vehicle, to confirm correct operation of the variable-assist speed proportional power steering gear.
