Concorde V6-3.2L VIN J (2000)
2. Install Spacer, Special Tool 6936, into the hub of the power steering pump pulley.
3. Insert the Pulley Installer, Special Tool C-4063, (without adapters) through hole in spacer. Thread the Installer into the end of the power steering
pump shaft. Tighten the installer into pump shaft.
4. Holding the Pulley Installer with one wrench so it will not rotate, turn hex down threaded rod of installer pushing the pulley onto the shaft of the
power steering pump. Ensure that the tool and the pulley remain aligned with the pump shaft so pulley does not become cocked on shaft.
5. Continue to push pulley onto shaft of power steering pump until Pulley Installer will no longer turn. This will ensure the spacer provided is fully
seated against the front of the power steering pump shaft.
6. Remove the Pulley Installer from the shaft of the power steering pump. Remove the Spacer from the hub of the power steering pump pulley.
7. Verify the pulley turns properly on the pump shaft.
